VQ Home  | Programs/Contacts  | QML/QPL Listings  | Qualification Part Search  | Commercial Lab Listing  | Qualified Suppliers List of Distributors (QSLD)  | Qualified Testing Suppliers List (QTSL)  | Downloads

List of Commercial Laboratories Suitable for Testing Military Devices

This is a list of commercial laboratories, which have a DLA Weapons Support-VQ letter of suitability to test to the military specifications indicated. Only commercial laboratories that have been issued laboratory suitability for a particular test method are eligible to test the federal stock class type of device called out in a laboratory suitability letter.

This list is divided into three sections; each section is dedicated to particular test standards and methods for which the laboratory has been given suitability.

The first column labeled  Laboratory  gives the name, address, phone number, and point of contact for each laboratory. The second column  Test Methods (Conditions)  lists the test standard (if more than one is included in a section), followed by a colon then the listing of methods from that particular test standard. If only certain conditions of a method are approved, they will be shown in parenthesis following the test condition (eg: 883: 1015, 1014, (A,B,E), 2003). These may include test methods such as those described in ASTM, IPC documents. The third column  Specification  lists the military specifications for QPL/QML electronic and construction components that the laboratory reports having tested. The last column  OPI  lists the DLA Land and Maritime Office of Primary Interest, which is the point of contact for any questions concerning that laboratory.

QPL/QML manufacturers using any of the facilities listed shall perform their own self audit of the commercial laboratory, initially and annually thereafter to verify continual compliance with the military requirements.

Laboratory suitability granted by DLA Weapons Support-VQ prohibits commercial laboratories from removing or altering the military specification marking required on the device. A device that fails testing conditions shall be identified (isolated) as a reject and returned to the manufacturer for verification of failure mode.

These commercial laboratories are subject to the conditions as stated in DoD 4120.24M (Defense Standardization and Specification Program, Policies, Procedures and Instructions) and SD-6 (Provisions Governing Qualification) and the December 2020 DLA Weapons Support-VQ Laboratory Suitability Information booklet.

This list will be revised periodically, but it is recommended that for current laboratory status, or to clarify any questions pertaining to the use of this list, the following individuals be contacted:

Standard(s)




Search by STANDARD:   All 1344 17 202 24728 28876 29504 364 38999 461 49291 55181 750 810 83526 83528 83538 83538 Test Par. 85045 85045: 17025 accredited 883 901 Conformal Coating DoD-1678 EIA-364 EIA/TIA IPC-TM-650 JEDEC MIL-DTL-22992 MIL-DTL-32139 MIL-PRF-28876 MIL-PRF-29504 MIL-STD-1678 MIL-STD-901 Misc PWB QTSL TIA TIA/EIA   AND/OR by TEST METHOD: